Configuring Remote Nodes With FrameFlow MSP

There’s an issue in the setup for FrameFlow MSP v6.7 that may affect you when  you are installing new remote nodes.

On the very last page of the setup and configuration there is an option to launch the web interface.   Of course all management of remote nodes is done from the master console so the remote node doesn’t have a web interface.
The check box is deselected by default but if you select it and press “Finish” the configuration utility will hang.  To work around this, just leave the option off and then press the Finish button.

And if you have accidentally selected it, that’s no problem.  The remote node setup is already complete at that point and you can safely use the Windows Task Manager to close the config utility.  We’ll get this fixed in the next maintenance release.

 

Leave a Reply

Your email address will not be published.

+ 84 = 92